Niagara Cutter 86030 Carbide Square Nose End Mill, Inch, TiAlN Finish, Roughing and Finishing Cut, 3

kalimat3 I will provide interesting information for you, you can get a Niagara Cutter 86030 Carbide Square Nose End Mill, Inch, TiAlN Finish, Roughing and Finishing Cut, 3 at a very cheap price especially for This day. But before you continue reading, please see reviews about Niagara Cutter 86030 Carbide Square Nose End Mill, Inch, TiAlN Finish, Roughing and Finishing Cut, 3 below

Features :

1. Three flutes provide better chip-carrying capacity than four flutes and a finer finish than two, reducing the need for a second finishing cut in some applications.
2. Titanium aluminum nitride (TiAlN) coating lubricates the end mill for high-temperature stability and abrasion resistance at high cutting speeds, offering better heat resistance than TiN and TiCN coatings.
3. Center-cutting design allows the end mill to plunge into material like a drill bit while also performing conventional surface milling.
4. Carbide can run at higher speeds than high-speed steel, resisting abrasion and high cutting temperatures.

Description

The Niagara Cutter C330 TiAlN-coated carbide square nose end mill has three flutes and a 30-degree helix angle for general-purpose machining on a range of materials. The tools square end creates sharp. The end mills three flutes provide better chip-carrying capacity than four flutes and a finer finish than two. They efficiently remove excess material from the cutting area and provide a third cutting edge to create an improved finish that may eliminate the need for a second finishing cut in some applications. The 30-degree helix angle supports general-purpose applications. It balances lower angles strong cutting edge for difficult-to-machine materials with higher angles increased cutting action. The TiAlN coating resists heat better than TiN and TiCN coatings, increasing tool life and performance. It also offers increased hardness for abrasion resistance and may reduce the need for lubricants based on the application. (TiAlN is suitable for a range of materials, but TiCN or uncoated end mills are recommended for machining aluminum. ) The carbide substrate is harder than high-speed or cobalt steel. Cutting diameter tolerance is +0. 000 to -0. 002. The round shank accommodates a variety of holders. End mills are designed to remove material and create multi-dimensional shapes and profiles.

Similar

• Niagara Cutter 56028 Carbide Ball Nose End Mill, Inch. 125" Cutting Diameter, 0. 125" Shank Diameter.
• Niagara Cutter 55803 Carbide Square Nose End Mill, Inch, TiAlN Finish. 125" Cutting Diameter, 0.
• Niagara Cutter 85436 Carbide Square Nose End Mill, Inch, TiAlN Finish. 5" Overall Length, 0. 125" Cutting Diameter, 0. 125" Shank Diameter.

Find out more